4. Here you can enter the desired fixed IP address.
Only applicable in fixed IP address mode.
5. Here you can enter the desired subnet mask.
Only applicable in fixed IP address mode.
6. Press this button to save the modified values.
Figure 11.20: Screen TCP/IP settings
11.4. Updating SW
After first startup it is advised to check if there are
SW updates available on the Televic website:
http://www.televic-conference.com/en/confidea_wcap?tab=207
Unzip the files to a location on your hard drive where
you can easily find them back .
Switch on the Confidea Access Point and all wireless
Confidea WDUs that need updating.
With a regular internet browser, go the Access Point
web server . (see also Note 11.2-1
To perform a SW update select the Service – Update
screen
Figure 11.21: Update screen
The configuration index is to be left at “1” (default).
SW update must be done in the following order
:
Note:
There must be a DHCP server on the
network that dynamically assigns IP
addresses when using the DHCP setting.
Note:
The new TCP/IP settings will only be
active after repowering the WCAP
To Next Page
Loading...
