Teltonika FMB010 - SMS COMMAND LIST; SMS command list

55
10
Speed
Value in km/h, 0 – xxx km/h
11
GSM Cell ID
GSM base station ID
12
GSM Area Code
Location Area code (LAC), it depends on GSM
operator. It provides unique number which
assigned to a set of base GSM stations. Max
value: 65536
13
Battery Voltage
Shows battery Voltage in mV
14
Battery Current
Shows battery Current in mA
15
Active GSM operator
Currently used GSM Operator code
16
Trip odometer
Distance between two records: m
17
Total odometer
Total odometer count: m
18
Digital Input 1
Logic: 0 / 1
19
Fuel Used GPS
Fuel used (ml) by GPS
20
Fuel Rate GPS
Fuel Consumption by average speed (l/100km)
21
Axis X
Accelerometer axis x value
22
Axis Y
Accelerometer axis y value
23
Axis Z
Accelerometer axis z value
*- make sure your vechicle supports OBD communication and related OBD codes.
There are two types of operations with Permanent I/O elements: simple
monitoring and event generating. Monitoring method is used when current I/O
information needed with regular GNSS coordinates. Event generating method is
used when additional AVL packet is needed when current value of I/O exceeds
predefined High and Low levels. I/O settings allow defining I/O event criteria.
6 SMS COMMAND LIST
All commands are case sensitive. While FMB010 operates in Sleep mode and user tries to
send SMS message it will arrive to FMB010 device, because GSM module is enabled. Only GNSS
module is disabled in sleep mode.
6.1 SMS command list
Table 4 SMS commands
Command
Description
Response
getinfo
Returns RTC time, GPS status, SAT
Yes
getver
Returns code version, device IMEI, modem app
version, RTC time
Yes
getstatus
Returns Data Link:0 GPRS:0 Phone:0 SIM:0 OP:24602
Signal:5 NewSMS:0 Roaming:0 SMSFull:0 LAC:0 Cell ID:
0
Yes
getgps
Returns GPS status, Satellite number, Latitude,
Yes