77
6.7.29 Trip priority priority (ID=11800)
Defines priority of trip scenario:
0 – disabled, 1 – low, 2 – high, 3 – panic
Goes with (depends on)
parameters
6.7.30 Start Speed (ID=11803)
This parameter represents speed, which is detected as minimum speed to indicate TRIP
START and generate event.
Goes with (depends on)
parameters
6.7.31 Ignition Off Timeout (ID=11804)
This parameter represents timeout to wait if ignition is off in order to detect TRIP STOP and
generate event.
Goes with (depends on)
parameters
6.7.32 Trip mode (ID=11802)
For this feature I/O ODOMETER must be enabled. If I/O ODOMETER is enabled, and mode
is set to Continuous (value 0), TRIP distance is going to be counted till the end of trip, if between
records mode is set, ODOMETER will count distance only between two records.
Goes with (depends on)
parameters
6.8 AutoGeofencing
6.8.1.1 AutoGeofencing priority (ID=20000)
Defines priority of trip scenario:
0 – disabled, 1 – low, 2 – high, 3 – panic
Goes with (depends on)
parameters
6.8.1.2 Activation Timeout (ID=20003)
Parameter represents AutoGeofencing activation timeout in seconds.
Goes with (depends on)
parameters
AutoGeofencing priority
(ID=20000)
To Next Page
