Teltonika FMB010 - Features settings; Trip settings

34
5. FMB will send response when calibration is success.
Calibration is saved to Internal Flash, after restart should be the same
To check autocalibration status send: position_info
To zero out accelerometer axis SMS: "calibrate", can be used, vehicle speed must be 0
km/h.
2. Over Speeding
Scenario is activated, when vehicle speed exceeds parameter value. Scenario is activated
until current speed decreases below parameter value.
3. Excessive Idling
Scenario is activated, when vehicle stops for specific amount of time. You can configure
time it takes to turn on this scenario (Time to Stopped). Scenario is activated until vehicle starts
moving and keeps moving for amount of time that is configured. You can configure time it takes
to turn OFF this scenario (Time to Stopped).
4. Jamming
Scenario is activated, when jamming is detected.
5. Trip
Scenario is activated, when ignition is on and movement is detected. Scenario calculates
distance user has moved.
5.1.9 Trip settings
Trip scenario offers user to configure Trip feature.
Start Speed – GPS speed has to be greater than the specified Start Speed in order to detect
Trip Start.
Ignition Off Timeout – timeout to wait if ignition was off, to detect Trip stop.
Continuous distance counting – Not or Continuous can be chosen. For this feature I/O
Odometer must be enabled.
If I/O Odometer is enabled and Continuous distance counting variable (Mode) is set to
Continuous, Trip distance is going to be counted continuously (from Trip start to Trip stop). This
value is written to I/O Odometer value field. When Trip is over and next Trip begins, Odometer
value is reset to zero. When the next trip starts counting continuously starts from the beginning
again.
If I/O Odometer is enabled and Continuous Distance Counting variable (Mode) is set
“Between Records”, then the distance is going to be counted only between every record made.
This value is written to I/O Odometer value field and reset to zero every new record until Trip
stops. If later all Odometer values are summed up manually, the user gets the distance driven
during the whole period of the Trip.