Tenda TEG3224P - Web Login Timeout Configuration; Config Port Settings; Port Mirroring Configuration

User Guide
196
5.3.9 Web login timeout configuration
TENDA(config)# http redirect timeout 300
Note: Config web login timeout interval as 300 seconds
TENDA# show http redirect timeout
Note: View web login timeout settings
5.3.10 Config port settings
TENDA(config)# interface gigabitethernet 0/3
Note: Enter the interface for configuring port 3
TENDA(config)# interface range gigabitethernet 0/3-8,12,15
Note: Enter the interface for configuring a batch of ports concurrently
TENDA(config-if)# speed 100
Note: Set port speed to 100
TENDA(config-if)# speed auto
Note: Set port speed to auto (auto-negotiation)
TENDA(config-if)# duplex full
Note: Set duplex to full duplex
TENDA(config-if)#cos 7
Note: Set port priority to 7
TENDA(config-if)# flow-control on
Note: Enable flow control
TENDA(config-if)# no shutdown
Note: Enable port
TENDA(config-if)# storm-control broadcast level 20%
Note: Set storm constrain ratio to 20%
TENDA(config-if)# port-isolated
Note: Enable port isolation
TENDA(config-if)# mtu 9600
Note: Set max jumbo frame size to 9600B on the port
5.3.11 Port mirroring configuration
TENDA(config)# monitor destination interface gigabitethernet 0/8
Note: Config port 8 as the mirroring destination port