Tenda TEG3224P - Mac Vlan; Protocol VLAN; Voice VLAN

User Guide
202
 View VLAN settings
TENDA(config)# show vlan 2-3
Note: View settings of VLANs 2-3
TENDA(config)# show vlan summry
Note: View settings of all VLANs
5.3.16 MAC VLAN
TENDA# configure terminal
TENDA(config)# vlan 2
Note: Create QVLAN2
TENDA(config)# mac-vlan 0000.0000.0001 vl1 vlan 2 cos 0
Note: Add MAC VLANs whose MAC address is 0000.0000.0001. It is described as v11 and
corresponds to vlan2 with cos 0.
TENDA# configure terminal
TENDA(config)# no mac-vlan 0000.0000.0001
Note: Delete the corresponding MAC VLAN whose MAC address is 0000.0000.0001
TENDA# show mac-vlan
Note: View MAC VLAN configurations
5.3.17 Protocol VLAN
TENDA# configure terminal
TENDA(config)# protocol-vlan marble eth-type 0x800 frame-type snap
Note: Create a protocol VLAN with the name “marble”, ethtype “0x800” and frametype “snap”
TENDA(config)# no protocol-vlan marble
Note: Delete the protocol VLAN named marnle
TENDA(config)# interface range gigabitethernet 0/3-5
TENDA(config-if)# protocol-vlan IP vlan 5
Note: Add protocol VLAN named IP on ports 3-5
TENDA(config)# interface range gigabitethernet 0/4
TENDA(config-if)# no protocol-vlan IP
Note: Remove protocol VLANs named IP on all ports
TENDA# show protocol-vlan
Note: Check protocol VLAN info
5.3.18 Voice VLAN
 Voice VLAN global settings
TENDA(config)# voice vlan secmode