Tenda TEG3224P - View RX;TX Packet Statistics; Config Port Rate Limit; Config Link Aggregation

User Guide
197
TENDA(config)# monitor source interface range gigabitethernet 0/1-3 rx
Note: Config ports 1-3 as mirroring source ports and sniffer mode as Ingress.
TENDA(config)# monitor source interface range gigabitethernet 0/4-5 tx
Note: Config ports 4-5 as mirroring source ports and sniffer mode as Egress.
TENDA(config)# monitor source interface gigabitethernet 0/6 both
Note: Config port 6 as mirroring source port and sniffer mode as Egress & Ingress.
TENDA(config)# no monitor
Note: Clear mirroring settings
5.3.12 View RX/TX packet statistics
TENDA# show interface gigabitethernet 0/2 counter
Note: View RX packet statistics on port 2
TENDA# show interfaces counter
Note: View statistics on all ports
5.3.13 Config Port Rate Limit
TENDA(config)# interface range gigabitethernet 0/1
TENDA(config-if)# rate-limit input 100
Note: Set ingress rate limit to 100M on port 1
TENDA(config-if)# rate-limit output 10
Note: Set egress rate limit to 10M on port 1
TENDA(config-if)# no rate-limit input
Note: Clear ingress rate limit on the port
TENDA(config-if)# no rate-limit output
Note: Clear egress rate limit on the port
5.3.14 Config Link Aggregation
 Create aggregation group
TENDA(config)# interface range gigabitethernet 0/1-4
Note: Set ports 1-4 as link aggregation member ports
TENDA(config-if)# trunk-group 1 type static
Note: Set aggregation group ID to 1 and type to static
TENDA(config-if)# trunk-group 2 type lacp
Note: Create a LACP static aggregation group: 2
 Delete aggregation group