Tenda TEG3224P User Manual

User Guide
217
Note: Configure IP address and subnet mask of virtual interface 2
TENDA(vlan-if)# enable
Note: Enable virtual interface 2
TENDA(vlan-if)# no enable
Note: Disable virtual interface 2
 Display virtual interface settings
TENDA# show interface vlan-interface all
Note: Display all virtual interfaces which have been created
TENDA# show interface vlan-interface 2
Note: Display settings on VLAN virtual interface 2
 Remote server configuration
TENDA(config)# ip helper-address 4 192.168.10.1
Note: Set remote server ID4, IP：192.168.10.1
TENDA(config)# no ip helper-address 4
Note: Delete remote server ID4
 DHCP relay configuration
TENDA(config)# interface vlan-interface 2
Note: Enter VLAN virtual interface 2
TENDA(vlan-if)# dhcp relay
Note: Enable DHCP relay on VLAN virtual interface 2
TENDA(vlan-if)# helper-address 1
Note: Select remote server ID1
TENDA(vlan-if)# no dhcp relay
Note: Disable DHCP relay on VLAN virtual interface 2
TENDA# show dhcp remoteserver
Note: Display remote server
 Display relay configuration
TENDA# show dhcp relay
Note: Display all relay configurations
5.3.32 DHCP Snooping
 Global settings

Tenda TEG3224P Specifications

General

Brand	Tenda
Model	TEG3224P
Category	Switch
Language	English