TESTO Saveris - Page 74

7 Using the product
74
Name Description
[Move to]
Move component/channel to another
alarm group.
Remove from group
Removes the component/channel
from the specified alarm group.
Delete this group
Deletes the entire alarm group.
Alarm settings channels
List of the available channels and their
affiliation to the selected alarm group.
Alarm settings for groups
Enter the group name.
System settings Alarm conditions: settings for lower
limit delay [measurements], upper limit
delay [measurements] and trigger
acknowledged alarms after [min]
Alarm output Saveris base: settings
for relays, audible signal and light
signal.
[Apply settings]
Saves the alarm settings of an alarm
group.
[Print]
Creates a file containing a summary of
the alarm settings for Saveris probes
and the Saveris base.
Create new group
1
Right-click on component, then click on [Insert into new group].

A new alarm group is created.
2
Overwrite the default names in Group alarm settings.
Move to…
1
Right-click on component, then click on [Move to …].

A selection of available alarm groups is displayed.
2
Click on required alarm group.

The component is assigned to the selected alarm group.
Remove from group