TESTO Saveris - Creating Recipient

7 Using the product
75
1
Right-click on component, then click on [Remove from group].

The component is removed from the assigned alarm group.
Delete group
1
Right-click on component, then click on [Delete this group].

The assigned alarm group is deleted, all components that were
assigned to this group are now without an alarm group.
7.2.6.4 Creating recipient
No configuration changes are transferred to the Saveris data
logger/Saveris base until you have exited the Alarm management
menu!
You should therefore exit the Alarm management menu after any
changes.
1
Click on Alarm management in the navigation area.

The following submenus are displayed in the data area:
• Alarm settings base
• Alarm settings component
• Alarm settings channel
• Alarm recipients
• Alarm rules
• Comments for acknowledging alarms
2
Click on Alarm recipients.

The recipient data are displayed in the display area.