Page 005
25-20-00
Martin-Baker
MISSION SEAT ETSO
MAINTENANCE MANUAL
MB680
I. Cushions installation
The back cushion assembly comes in two parts, a cushion back - front, and a cushion back -rear.
The cushion back - rear is attached to the backrest assembly with touch and close fasteners.
The cushion back - front is attached to backrest assembly with touch and close fasteners, and to the
cushion back - rear with a touch and close fastener plus four snap-stud fasteners.
The cushion back - front has two straps for the lumbar cushion which is provided to give back support.
The lumbar cushion has two channels through which two straps on the back cushion are threaded before
they are connected to two snap-stud fasteners.
The sitting cushion is attached to the bucket assembly with touch and close fasteners. The cushion has
tabs at the front and sides for the 5-point harness lap straps and negative g strap to pass through.
To Next Page
Loading...