Textron Cessna 182S - Page 176

CESSNA AIRCRAFT COMPANY
MODEL 182/T182
WIRING DIAGRAM MANUAL
CAUTION: DO NOT NICK OR CUT CENTER CONDUCTOR.
(10) Trim center conductor to depth of contact solder pot so contact is flush with dielectric.
(11) Tin center conductor lightly.
(12)
Install and solder contact
on center conductor.
(13) Install gasket and braid clamp.
(14) Insert complete
assembly into connector
body so contact
enters hole in insulator
and braid clamp
seats properly. Push assembly into
body as far as possible. Start connector
nut by hand and
tighten moderately with wrench.
(15) Hold
connector body and
tighten to torque value
of 40 inch-pounds
+10, -10 inch-pounds.
4.
Assembly MIL-C-25516
(M25516/20-XX-XX) Connectors.
A. Assembly
Procedures. Refer
to Figure 203.
B. Instructions also cover Ted Manufacturing
Corporation Series 59 and 69 connectors
for shielded
cables.
5.
Assembly 2755-2-9
King K-Grip Connectors
A.
Assembly Procedures.
Refer to Figure
204.
0
Cessna Aircraft
Company
20-10-05
Page
202
Mar 1/2004