Textron Cessna 182S User Manual

CESSNA AIRCRAFT COMPANY
MODEL 182/T182
WIRING DIAGRAM MANUAL
COAX CABLE CONNECTORS - MAINTENANCE PRACTICES
1.
General
A. The following information is intended for replacement of coax cable connectors in general. Instructions
given are typical for coax cable connectors.
B. Coax cable connectors described herein are of two types: one utilizing a threaded-type braid clamp,
the other a swaged-type braid clamp.
2. Installation/Assembly Coax Cable Connectors (Threaded Type)
A. Assembly Procedures. Refer to Figure 201.
(1)
Cut coax
cable to length.
(2) Trim jacket approximately 5/16 inch from end of cable.
(3) Slip clamp
nut, washer, gasket and
braid clamp onto cable.
(4)
Flare
braid
over braid
clamp.
(5) Strip insulation from center
conductor to depth of contact
solder pot.
(6) Install
and solder
contact
to center
conductor.
NOTE: Nuts having captivated contacts, washer and insulator are assembled before
soldering contacts.
(7) Insert complete assembly into connector body so contact enters hold in insulator properly.
(8) Start connector
nut by hand and tighten to 40 inch pounds
+10, -10 inch-pounds, torque.
3. Installation/Assembly Connectors with K-Grips (Swaged Type)
A. Assembly Procedures. Refer to Figure 202.
(1) Disassemble nut, gasket and braid clamp from connector body. Remove K-Grip and sleeve from
individual package.
(2) Slip K-Grip sleeve and connector nut onto cable.
(3) Remove
outer jacket to dimension
A. Refer to Table 201.
Table 201. K-Grip Assembly
Connector Dimension Dimension Dimension K-Grip Tool
A Inches Bnches I nches C Inches
UG-913A/U 1.18
0.3 0.111 KS-89-05
683-51470-1
UG-88C/U 1.18 0.3
0.111 KS-89-05
683-51470-1
CAUTION: DO NOT NICK OR CUT THE BRAID.
(4) Trim braid to dimension B with
small scissors or fingernail clippers.
Refer to Table 201.
(5) Slide grooved slotted end of K-Grip barrel over dielectric and under braid until braid touches step
of barrel.
(6) Slide connector nut
in place so that nut butts against
collar of K-Grip barrel.
NOTE: Nut must be correctly positioned before crimping.
(7) Hold K-Grip barrel in position and
slide K-Grip sleeve until forward edge of
sleeve is even with
step of barrel and the braid is visible between sleeve and step.
(8) Crimp K-Grip sleeve as
shown using tool specified in Table 201.
If an alternate tool is used,
crimp sleeve twice to utilize
full length of sleeve, yet leave
a flare at each end.
(9) Trim dielectric to dimension C in Table 201.
20-10-05 Page 201
© Cessna Aircraft Company Mar 1/2004

Textron Cessna 182S Specifications

General

Brand	Textron
Model	Cessna 182S
Category	Tools
Language	English