Textron Cessna 182S User Manual

CESSNA
AIRCRAFT
COMPANY
MODEL 182/T182
WIRING
DIAGRAM MANUAL
ELECTRICAL SAFETY PRECAUTIONS
1.
General
A. This
section contains
general information
on physical
and chemical
processes
which require
the use
of chemicals,
solvents
or other
commercially
available materials.
B. The user of this
publication should obtain
the material safety
data sheets (Occupational
Safety and
Health
Act (OSHA) Form 20
or equivalent) from the
manufacturers or suppliers
of materials to
be used.
The
user must become
completely
familiar with
the manufacturer/supplier
information
and adhere to
the procedures,
recommendations,
warnings, and cautions
of the manufacturer/supplier
for the safe
use, handling,
storage
and disposal
of these materials.
Users of
this manual are
also advised
to refer
to pertinent
safety information contained
in the "NIOSH
Occupational Guideline
for Chemical Hazards"
published
by the United
States Department
of Labor.
C.
WARNINGS are
provided to alert
operating and
maintenance
personnel to
potential hazards
that could
result
in personal injury;
they do not replace
the manufacturers'
recommendations.
D. CAUTIONS
are provided
to alert operating
and maintenance
personnel
to conditions
that could
result
in
equipment
damage.
2.
General Safety
Warnings
WARNING:
BEFORE USING
ANY OF THE FOLLOWING
MATERIALS,
BE AWARE OF
ALL
HANDLING, STORAGE
AND DISPOSAL
PRECAUTIONS
RECOMMENDED
BY THE
MANUFACTURER
OR SUPPLIER.
FAILURE TO COMPLY
WITH MANUFACTURER'S
OR
SUPPLIER'S
RECOMMENDATIONS
MAY RESULT
IN SERIOUS
INJURY,
PHYSICAL
DISORDER OR DEATH.
A. Xylene
is toxic and flammable.
Do
not breathe vapors.
Use in a well
ventilated
area free from
sparks,
flame
or hot surfaces. Wear
splash goggles, solvent
resistant gloves
and other protective
gear. In
case
of eye contact,
flush with
water and seek
medical attention.
In case
of skin contact,
wash with
soap and water.
B. Isopropyl alcohol
is toxic. Do not
breathe vapors. Use
in well ventilated area
free from sparks, flame
or
hot surfaces. Wear splash
goggles, solvent
resistant gloves and
other protective gear.
In case of
eye contact, flush
with water
and seek medical
attention.
In case of skin
contact, wash
with soap
and
water.
C. 1,1,1 trichloroethane
is toxic. Do not
breathe vapors. Use
in well ventilated area
free from sparks,
flame or hot
surfaces. Wear splash
goggles, solvent
resistant gloves and
other protective gear.
In
case of eye contact,
flush with water and
seek medical attention.
In case of skin
contact, wash with
soap
and water.
D. Acid
chromate deoxidizing
solution is corrosive
to human tissue. Do
not breathe vapors.
Use in well
ventilated area.
Wear chemical resistant clothing, gloves,
splash goggles and face shield. In case
of
eye
or skin contact,
flush with
water and seek
medical
attention.
E. Chromate
chemical conversion
coating and nitric acid
are both corrosive to
human tissue. Do not
breathe vapors. Use
in well ventilated area. Wear chemical resistant
clothing, gloves, splash goggles
and face shield.
In case
of eye or skin
contact, flush
with water
and seek medical
attention.
F. Alcohol base rosin
solder flux is flammable. Use in well ventilated
area free from sparks, flame or hot
surfaces.
G. When using
compressed air for cleaning or drying,
regulate pressure to 29 pounds per square
inch
or
less. Wear goggles or
face shield to protect
eyes.
3. General Cautions
A. Solder type relay terminals to which
no leads are connected should be protected
with shrinkable tubing
to prevent the
possibility of shorting
or grounding resulting
in erratic operation
or damage.
B. Reduce all power supplies to zero before connecting or disconnecting electrical devices.
20-10-00 Page 1
© Cessna Aircraft Company Mar 1/2004

Textron Cessna 182S Specifications

General

Brand	Textron
Model	Cessna 182S
Category	Tools
Language	English