Textron Cessna 182S - SPLICES AND TERMINALS

CESSNA AIRCRAFT COMPANY
MODEL 182/T182
WIRING DIAGRAM MANUAL
SPLICES
AND
TERMINALS
1. General
A. This section contains
information for replacement of
splices and terminals.
B. The
splices covered are
of two types: one a permanent
crimp-type
splice that must be destroyed
to
separate the wires,
the other a quick-disconnect
that can be connected
and disconnected
repeatedly.
C. The
terminals covered
are crimp-type
in straight
and flag type.
D. All wire sizes referenced
are American Wire Gauge
(AWG).
2.
Splices - Quick Disconnect
Non-environmental
A.
Refer to Table 201
for splice part numbers.
B. For installation,
use WT110M
crimp tool available
through
Thomas and Betts
Table 201.
Quick Disconnect Non-environmental
Splices
WIRE SIZE PART NUMBER
22
Thru 18
S341-2
16
Thru 14
S341-1
3. Splices
- Permanent Non-environmental
A. Permanent crimp
non-environmental
splices may be used
on various wire sizes
or combinations of
wires.
Refer to table 203 for
splice wire size information.
B. The crimp
tools listed in Table
202 or their equivalent
are required to install
these splices. All
crimp
tools listed are available through AMP Inc. V00779.
NOTE:
The splice crimping
tool has an insulation
crimping adjustment
set to 1, 2, 3 or 4 depending
on the
thickness
of insulation.
The splice should
have a
firm crimp on
the insulation
without
damage.
Table 202. Tools for
Permanent Crimp Non-environmental
Splices
AWG
SPLICE
CRIMPING TOOL
22-16
320559
59250
14-16
320562
59250
10-12
320570
59239-4
22-16
S1370-1
59250
14-16
S1370-2
59250
10-12
S1370-3
59239-4
20-10-06
Page
201
© Cessna Aircraft
Company
Mar 1/2004