Textron Cessna 182S - Page 198

CESSNA
AIRCRAFT
COMPANY
MODEL 182/T182
WIRING
DIAGRAM
MANUAL
Table 213. Standard Flag Terminals (continued)
WIRE SIZE (AWG) STUD SIZE PART NUMBER
4
10
MS25189-12
4
1/4
MS25189-13
4
5/16
MS25189-14
4
3/8
MS25189-15
4
1/2 MS25189-16
2 10 MS25189-17
2
1/4
MS25189-18
2
5/16
MS25189-19
2 3/8 MS25189-20
2 7/16 MS25189-21
2 1/2 MS25189-22
NOTE: The flag terminals listed in Table 214 are for use in fuel cells.
Table 214.
Fuel Quantity Probe
Flag Terminals
NAME PART MANUFACTURER
NUMBER
#6 Terminal 36195 AMP Inc. V00779
#8 Terminal 34117 AMP Inc. V00779
#10 Terminal 34118 AMP Inc. V00779
Crimper
WT111
M Thomas and
Betts
#6 Terminal AB51 Thomas and Betts
#8 Terminal AB52 Thomas and Betts
#10 Terminal AB53 Thomas and Betts
12. CHECKING
TERMINALS AND
SPLICES
A. Electrical Resistance.
(1) Properly installed terminals and splices shall offer no more resistance across the terminal than
an equivalent
length of wire of the same gage
to which the terminal is attached.
B.
Tension
Load Testing.
(1) To test crimping tools used for installing terminals and splices, a sample wire and terminal or
splice should withstand the tension loads in Table 215.
20-10-06 Page 214
© Cessna Aircraft Company Mar 1/2004