iCNC PERFORMANCE
Manual 0-5399 OPERATION 3-5
The Cut again box allows the opportunity to suspend and save a current job and restart a saved job.
• Cancel – Cancel any selected functions under the Cut again box
• Show new start point – Selecting this function allows the user to point the pierce point that will start the cut. Parts before the
selection will be ignored.
• Restart - After locating a new pierce point, select Restart to start cutting cycle
• Zoom – Allows easier pierce point location on a nest by zooming-in on a part
• Save job – Will store existing suspended program to a temporary file
• Reload saved job – Brings back the suspended saved program from the temporary file
www.TechnicalBooksPDF.com
To Next Page
