iCNC PERFORMANCE
5-20 NESTING Manual 0-5399
5.3.21 Align Parts
Use this tool to align the plate with the X or the Y axis. Why? Automatic nesting performs better if the bottom edge of the plate is
aligned with the X or the Y axis.
5.3.22 Change Split
Use this tool to change between parts displayed. See Edit Plate.
5.3.23 Rotate Plate
This tool rotates the current plate 90 degrees counter clockwise.
5.3.24 Mirror Plate
Use this tool to mirror the current plate in Y-axis.
5.3.25 Move to Origin
This tool repositions the current plate. After the plate is repositioned, its minimum X-and Y-coordinates are equal to zero.
5.3.26 Undo Plate Edit
Edit Plate-tool splits a plate into two parts. If you made some errors during editing, use this tool to bring the original plate back
www.TechnicalBooksPDF.com
To Next Page
Loading...
