7-2 Model 310 Series DH Incubator Thermo Scientific
Section 7
Specifications
Shelves
Dimensions . . . . . . . .18.5” x 18.5” (47cm x 47cm
Construction . . Stainless steel (belt sanded, both sides)
Surface area . . . . . .2.4 sq. ft. (0.22 sq. m) per shelf
Max. per chamber . . . . . . . . .38.4 sq ft (3.6 sq. m)
Loading . . . .35 lbs (16kg) slide in and out, 50 lbs (23kg) stationary
Standard . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Maximum . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Construction
Interior volume . . . . . . . . . . . . . . . . . . . .6.5 cu. ft.
Interior . . . . . .Type 304 stainless steel shiny finish
Exterior . . . . . . . . . . . . . . . .18 gauge cold roll steel
Outer door gasket . . Four-sided molded, magnetic vinyl
Inner door gasket . . . . . . .Feather-edge, removable
Insulation . . . . . . . . . . . . . . . . . . . . . . . .Fiberglass
Fittings
Access port . . . .1-1/4 inch removable silicone plug
CO
2 inlet . . . . . . . . . . . . . . . . . . . . . . .1/4” barbed
Sample port . . . . . . . . . . . . .Front mounted barbed
Electrical
115 Volt models -
90-125VAC, 50/60 Hz, 1PH, 2.4 FLA
230 Volt models -
180-250, 50/60 Hz, 1 PH, 2.0 FLA
Power switch/circuit breaker . . . . .2 Pole, 6.0 Amp
Accessory outlet . . Voltage equal to the cabinet input,
75 Watts maximum, 0.5ma leakage current
Alarm contacts . . Deviation of temperature, CO
2, power, NO and NC
Unit BTU Output
115/230V . . . . . . . . . . . . . .344 BTUH (100 watt)
Dimensions
Exterior . . . . . . . . .26.0” W x 38.5” H x 25.0” F-B
Interior . . . . . . . . .21.4” W x 26.8” H x 20.0” F-B
To Next Page
Loading...
