Thermo 42i - Remove the Packing Material

Installation
Unpacking and Inspection
2-2 Model 42i Low Source Instruction Manual Thermo Electron Corporation
3. Remove the packing material.
Figure 2-1. Remove the Packing Material
4. Remove the three shipping screws (Figure 2-2).
Figure 2-2. Remove the Shipping Screws
5. Check for possible damage during shipment.
6. Check that all connectors and circuit boards are firmly attached.
Units without Optional I/O Board
Units with Optional I/O Board
Remove Packing
Remove Packing
(2 pieces)
(2 pieces)
Shipping Screws (3)