C-Link Protocol Commands
Measurement Configuration
B-28 Model 42i Low Source Instruction Manual Thermo Electron Corporation
sc
screen
This command is meant for backward compatibility on the C series. Screen
information is reported using the “iScreen” command above.
Send: screen
Receive: screen This is an I series Instrument. Screen Information
not available
Measurement
Configuration
range no
range no2
range nox
high range no
high range no2
high range nox
low range no
low range no2
low range nox
These commands report the NO, NO
2
, and NO
x
ranges in single range
mode, or the high and low ranges in dual or auto range mode, according to
Table B-6 and B-7. If the mode is incorrect, the instrument responds with
“can’t, wrong settings”. The example below reports that the NO range is set
to 100,000 ppb (extended ranges).
Send: range no
Receive: range no 6: 1000E+2 ppb
set range no selection
set range no2 selection
set range nox selection
set high range no selection
set high range no2 selection
set high range nox selection
set low range no selection
set low range no2 selection
set low range nox selection
These commands select the NO, NO
2
, and NO
x
full-scale ranges,
according to Table B-6 and B-7. The example below sets the NO
x
full-scale
to 100,000 ppb (extended ranges).
Send: set range nox 6
Receive: set range nox 6 ok
To Next Page
Loading...
