Operation
Diagnostics Menu
Thermo Electron Corporation Model 42i Low Source Instruction Manual 3-71
Set Analog Outputs The Set Analog Outputs screen contains three choices: Set to full-scale, set
to zero, or reset to normal. Full-scale sets the analog outputs to the full-scale
voltage, zero sets the analog outputs to 0 volts, and normal operation. The
example below shows the selected output state “ALL” is set to normal.
• In the Main Menu, choose Diagnostics > Test Analog Outputs > ALL,
Voltage Channel 1-6, or Current Channel 1-6.
• Use and to move the cursor up and down.
• Press to select a choice.
TEST ANALOG OUTPUTS:
>ALL
VOLTAGE CHANNEL 1
VOLTAGE CHANNEL 2
VOLTAGE CHANNEL 3
VOLTAGE CHANNEL 4
VOLTAGE CHANNEL 5
VOLTAGE CHANNEL 6
ª
RANGE AVG DIAGS ALARM
SET ANALOG OUTPUTS:
SETTING: ALL
OUTPUT SET TO: NORMAL
© SET TO FULL SCALE
ª SET TO ZERO
§ RESET TO NORMAL
RANGE AVG DIAGS ALARM
To Next Page
Loading...
