To Next Page

To Previous Page

90 DCx camera

is_AddToSequence()

Adds image memory to the sequence list.

is_ClearSequence()

Deletes the entire sequence list.

is_GetActSeqBuf()

Determines the image memory currently used for the sequence.

is_SetImageMem()

Makes the indicated image memory the active memory.

is_LockSeqBuf()

Protects the sequence image memory from being overwritten.

is_UnlockSeqBuf()

Releases the sequence image memory for overwriting.

7.2.2

Display Mode Selection

The DCx camera driver provides different modes for displaying the captured images on Windows

systems. We recommend using the Bitmap mode or the Direct3D functions, depending on your

specific application.

For further information on the different display modes, see Basics: Image Display Modes .

Select the desired mode. The display mode has to be set before you start image capture.

is_SetDisplayMode()

Selection of the display mode.

When Bitmap mode (DIB) is active, image display has to be called explicitly for each image.

is_RenderBitmap()

Outputs the contents of the active image memory to a window.

is_SetDisplayPos()

Enables offsetting the image output inside the window.

118

126

151

270

203

291

371

246

205

248

THORLABS DCC1645C User Manual

Other manuals for THORLABS DCC1645C