© 2016 Thorlabs Scientific Imaging
4 Programming (SDK)
165
sizeof(nVerticalAoiMergeModeHeightNumber));
if (nRet == IS_SUCCESS)
{
UINT* pVerticalAoiMergeModeHeightList = new UINT[nVerticalAoiMergeModeHeightNumber];
/* Get the vertical AOI merge mode height list */
nRet = is_DeviceFeature(hCam, IS_DEVICE_FEATURE_CMD_GET_VERTICAL_AOI_MERGE_HEIGHT_LIST,
(void*)pVerticalAoiMergeModeHeightList,
nVerticalAoiMergeModeHeightNumber * sizeof(UINT));
if (nRet == IS_SUCCESS)
{
/* Set the maximum possible vertical AOI merge mode height depending on the current image height */
UINT nMaxHeight = pVerticalAoiMergeModeHeightList[nVerticalAoiMergeModeHeightNumber - 1];
nRet = is_DeviceFeature(hCam, IS_DEVICE_FEATURE_CMD_SET_VERTICAL_AOI_MERGE_HEIGHT,
(void*)&nMaxHeight, sizeof(nMaxHeight));
}
}
Example 3
UINT nModes;
/* Get mask with all supported vertical AOI merge line modes */
INT nRet = is_DeviceFeature(hCam, IS_DEVICE_FEATURE_CMD_GET_VERTICAL_AOI_MERGE_MODE_SUPPORTED_LINE_MODES, (void*)&nModes, sizeof(nModes));
if (nRet == IS_SUCCESS)
{
if (nModes & IS_VERTICAL_AOI_MERGE_MODE_LINE_FREERUN)
{
// freerun supported
}
if (nModes & IS_VERTICAL_AOI_MERGE_MODE_LINE_SOFTWARE_TRIGGER)
{
// software triggered supported
}
if (nModes & IS_VERTICAL_AOI_MERGE_MODE_LINE_GPIO_TRIGGER)
{
// GPIO triggered supported
}
}
4.3.15.2 Using the Log Mode
Syntax
INT is_DeviceFeature (HIDS hCam, UINT nCommand, void* pParam, UINT cbSizeOfParam)
Description
Using is_DeviceFeature() you can configure special camera functions provided by specific uc480
models:
DCC1240/DCC3240
The nCommand input parameter is used to select the function mode. The pParam input parameter
depends on the selected function mode. If you select functions for setting or returning a value,
pParam contains a pointer to a variable of the UINT type. The size of the memory area to which
pParam refers is specified in the cbSizeOfParam input parameter.
Input parameters
To Next Page
Loading...
Need help?
General
