www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
2. Unfix the X Axis and coupler
Unfix the X Axis then loose one of the coupler ensure each sides can move separately.
Measure by ruler, make sure they are the same distance as follow:
Then tighten the screws for each side of X Axis firstly, please do it carefully by tighten slowly to
ensure the angle of X Axis doesn’t change. After fix them then measure the distance again, ok,
then fix the rest of the screws. It’s ok if the error within 0.5mm. finally, fasten the screws of the
coupler.
End
To Next Page
Loading...
