16
HANDLING THE HIGH PRESSURE HOSE / INTERRUPTION OF WORK
ELITE 3000
6 HANDLING THE HIGHPRESSURE HOSE
The unit is equipped with a high-pressure hose specially suited
for diaphragm pumps.
Danger of injury through leaking high-pressure
hose. Replace any damaged high-pressure hose
immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against sharp
objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Titan spray gun with a swivel joint and a
hose system.
When using the high-pressure hose while
working on scaolding, it is best to always guide
the hose along the outside of the scaolding.
The risk of damage rises with the age of the high-
pressure hose.
Titan recommends replacing high-pressure
hoses after 6 years.
Only use TITAN original-high-pressure hoses with
internal heating in order to ensure functionality,
safety and durability.
7 INTERRUPTION OF WORK
1. Set pressure relief valve to (pressure relief, circulation).
Switch the pump OFF using the ON/OFF switch (Pos. 0).
2. Pull trigger of the spray gun to decrease the pressure of
the high pressure hose and the spray gun.
3. Secure the spray gun trigger, refer to the operating manual
of the spray gun.
4. Remove tip from tip holder and store the tip in a small
vessel with suitable cleaning agent.
5. Leave the suction system immersed in the coating material
or immerse it in the corresponding cleaning agent. The
suction lter and unit should not dry out.
6. Cover the material container in order to prevent the paint
from drying.
In using quick-drying or two-component coating
materials, do not fail to rinse unit through with
a suitable cleaning agent during the processing
period.
To Next Page
Loading...
Need help?
General
