Topcon KR-1 - AUTO MODE MEASUREMENT; SETTING THE AUTO MODE

27
BASIC OPERATIONS
AUTO MODE MEASUREMENT
SETTING THE AUTO MODE
1 Make sure the button is on A on the measurement screen. "A" is Auto
mode.
2 If "M" (Manual mode) is displayed, tap it and change to the Auto mode.
NOTE:
Auto measurement mode may not be possible, in case the eyelid and
the eyelashes cover the pupil.
If this occurs, the operator should tell the patient to open their eyes as
wide as possible, or lift the eyelid to allow for measurement.
NOTE:
Auto measurement mode may not be possible due to frequent blinks
or existing abnormalities in the corneal surface caused corneal dis-
ease etc.
In this case, select manual mode.
NOTE:
When operating the instrument, be careful that the instrument does
not touch the patient's face or nose. If touched, clean the instrument
as specified in "CLEANING THE INSTRUMENT" on page 65.
NOTE:
If the patient is wearing make up on the eyelid or around the eyelid
using glitter, the auto alignment may not function properly.
In this case, select manual mode.
AUTO/MANUAL
R
ID
L
R/K
00001000010000000100001000 00001000010000000100001000
13.7513.75
mmmm
010 1
R
S
C
A
K
R1
R1
R2R2
A1A1
PR1PR1
PR2PR2
0/30/3
0/30/3
0/30/3
0/30/3
R
S
C
A
K
R1
R1
R2R2
A1A1
PR1PR1
PR2PR2
VDVD
A
AUTOAUTO
PA1PA1 PA1PA1
LOWLOW
FOGFOG