Topcon KR-1 - OPTIONAL OPERATIONS; DISPLAYING THE PATIENT ID (PATIENT No.) OR OPERATOR ID; MEASURING ONE EYE ONLY

38
OPTIONAL OPERATIONS
OPTIONAL OPERATIONS
DISPLAYING THE PATIENT ID (PATIENT No.) OR OPERATOR ID
A patient ID or operator ID of up to 13 characters can be input and displayed on the control
panel and printout.
However, if no patient ID is input, the patient No. is allocated automatically by the device.
1 Tap button.
2 Tap keyboard on the screen and enter characters. Tap button and fix the input value.
MEASURING ONE EYE ONLY
In Auto mode, it is possible to measure one eye only.
The current measurement position is distinguished by the color of the / button; orange
indicates active measurement position.
MEASURING THE RIGHT EYE ONLY
1 Tap the button to move the measuring head to the right.
2 When the measuring head stops moving tap the button once again: the lock icon is
displayed .
• When the lock icon is displayed, the measuring head does not move to the other eye even
when the measurement of one eye is finished.
3 To release the lock, tap the icon: The lock icon disappears.
MEASURING THE LEFT EYE ONLY
Operation is the same as measuring the right eye.
Patient ID is reset when measurement values are printed or if the but-
ton is tapped.
Patient No. reset condition can be selected such that the patient No. is reset upon
power on or not, in the initial setting of setup screen.
"Refer to "Patient No.reset" on page 48.
In order to measure the other eye when the lock icon is displayed, tap the other
side button or button.
ID
OK
ALL CLEAR
R L
R/K
00001000010000100001
00001000010000100001
0000100001
0000100001
13.75
13.75
dio
di o
01
0 1
VD
VD
ID
A
mm
mm
AUTO
AUTO
R
S
C
A
K
R1
R1
R2
R2
A1
A1
PR1
PR1
R
S
C
A
K
R1
R1
R2
R2
A1
A1
PR1
PR1
LOW
LOW
FOG
FOG
0/3
0/3
0/3
0/3
0/3
0/3
0/3
0/3
PR2
PR2
PA1
PA1
PR2
PR2
PA1
PA1