Topcon KR-1 - Page 51

49
SETTING FUNCTIONS ON SETUP SCREEN
Axis step
1° Axial angle is displayed by 1° step.
1°
5° Axial angle is displayed by 5° step.
VD
0.00 VD value is set to 0mm (contact lens).
13.7512.00 VD value is set to 12.00mm (eyeglass lens).
13.75 VD value is set to 13.75mm (eyeglass lens).
ADD
NO
40-44
45-49
50-54
55-59
60-64
65-69
70-74
The typical additional power for the age can be selected. NO
D or mm(KRT)
D D (diopter) of corneal refractive power.
mm
mm mm of corneal curvature.
HV or R1R2
HV
Corneal curvature radius measurement result on screen is
displayed by HV.
R1R2
R1R2
Corneal curvature radius measurement result on screen is
displayed by R1R2 (flat/steep meridian).
Show KRT unit
OFF KRT unit is not shown.
ON
ON KRT unit is shown.
Cylinder sign
- Cylinder sign is " - ".
- + Cylinder sign is "+".
MIX Cylinder sign is "+" and "
- ".
Init. measure
mode
REF Default measurement mode on is REF.
REF/KRTREF/KRT Default measurement mode is R/K.
KRT Default measurement mode is KRT.
Pupil distance
58mm
60mm
62mm
64mm
66mm
68mm
70mm
72mm
74mm
Set by up/down button.
Sets the pupil distance between right and left eyes. 68
R/L move
Manual The switching of right and left eyes is performed at "Manual".
Full Auto
Full Auto
The switching of right and left eyes is performed at
"Full Auto".
Auto (RL)
The switching of right and left eyes is performed at
"Auto(RL)".
R/L notation
R/L Right/left eyes is displayed by R/L.
R/L
OD/OS Right/left eyes is displayed by OD/OS.
Peripheral KRT
OFF Peripheral KRT measurement is off.
OFF
ON Peripheral KRT measurement is on.
Chin rest height
HIGH
CENTER
LOW
Default chinrest height. LOW
Control panel
brightness
Level 1 (dark)
The brightness of control panel. Level 4
Level 2
Level 3
Level 4 (bright)
Picture printer
Normal Printer Picture of refractive condition is not printed.
Normal
Printer
Graphic Printer Picture of refractive condition is printed.
REF average
OFF REF average is not displayed.
OFF
ON REF average is displayed.
Descriptions Options Details Initial value