Toro Reelmaster 5510-D - Page 513

DisassemblingtheControlArm(continued)
g185936
Figure306
1.Foamseal
2.Platformwireharness
AssemblingtheControlArm
1.Installalltheelectricalcomponentsthatwereremovedfromthecontrolarm
(Figure304).
2.Positionthecoverstothecontrolarm.Astheleftcontrolarmcover(item32
inFigure304)isplaced,connectthewireharnessconnectortotheheadlight
switch.Also,ensurethattheplatformwireharnessisroutedcorrectly
throughthecoveropeningsandtheharnessfoamsealiscapturedbetween
thecontrolarmcovers(Figure306).
3.Secureeachcovertothecontrolarmwiththe5washer-headscrews(item
15inFigure304).Installthescrew(item11inFigure304)andlocknutto
securethecoversatthefrontofthecontrolarm.
4.Installtheaccesscovertooutsideofthecontrolarm.
5.Connectthenegativebatterycabletothebattery;refertoServicingthe
Battery(page7–125).
Reelmaster
®
5410/5510/5610Series
Page8–25
Chassis:ServiceandRepairs
15216SLRevC