Toro Sentinel - Advanced Flow and Master Settings; Flow Factors Meter 1 Setup; N;O Master Configuration

13
Flow Factors Meter 1 (4 Fields to set: K and Offset X whole and decimal values)
Flow factors are the K and offset for each meter, used to determine the ow rate in gallons per minute or liters per minute from the raw pulse
rate of the meter. Flow factors are determined by the pipe size and type.
Enter/edit the K factor associated with the ow metering device being used. The K factor may be found in the specication sheet for the
ow meter. The Offset factor may be found in the specication sheet for the ow meter.
N/O Master (1 Field to set)
Congure the master valve/pump start output for either normally OPEN or normally CLOSED operation.
2 3 41
ENTER
- OR -
ENTER
- OR -
2 3 41
ENTER
- OR -
ENTER
- OR -
Flow Factors Meter 1
K = 0003.000
Offset = 1.000
** SAVED! **
K = 0003.000
Offset = 1.000