Fuel T ank Installation (continued)
g421556
Figure 67
2. Using a T40 torx driver , install the 4 (5/16 inch) bolts to secure the badge
plate assembly to the chassis.
g421527
Figure 68
3. Install the RH pod. Refer to Right Hand Pod Installation ( page 6– 23 ) .
4. Install the fuel ller neck. Install the hose clamp securing the fuel ller neck
to the fuel tank.
5. Install the LH pod. Refer to Left Hand Pod Installation ( page 6– 21 ) .
6. Connect the fuel line to the fuel tank and secure the fuel line.
7. Connect the vent hose to the fuel tank.
2000 Series Z MASTER®Service Manual Page 6–1 1 Chassis: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
