Toshiba e-studio555 - Page 105

4
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
GENERAL OPERATION
4 - 9
(C) Misfeeding in equipment
• The fuser transport sensor (S9) detects jamming of the leading edge of the paper.
The registration motor (M16) is turned ON.
↓
The fuser transport sensor (S9) is not turned ON within a fixed period of time.
↓
Paper jam (E010) → The copying operation stops.
• The fuser transport sensor (S9) detects jamming of the tailing edge of paper.
The registration motor (M16) is turned OFF.
↓
The fuser transport sensor (S9) is not turned OFF after a fixed period of time.
↓
Paper jam (E020) → The copying operation stops.
• Immediately after the power is turned ON;
↓
Any of the sensors on the paper transport path detects the paper (ON).
↓
Paper jam (E030)
• The front cover (lower) opens during copying.
↓
Paper jam (E410)
• The registration sensor (S18) detects jamming of the leading edge of the paper:
The registration sensor (S18) is not turned ON within a fixed period of time after the leading edge of
paper passes the transport roller.
↓
Paper jam (E200, E210, E300, E330, E260, E110 and E3C0)
• The intermediate transport sensor (S17) detects jamming of the leading edge of the paper:
The intermediate transport sensor is not turned ON within a fixed period of time after the leading
edge of paper passes the 1st drawer transport sensor (S33).
↓
Paper jam (E201, E211, E301, E331, E3C1, E261 and E2A1)
• Each drawer transport sensor (S33, 39, 45, 51) detects jamming of the leading edge of the paper:
The transport sensors (S33, 39, 45, 51) are not turned ON within a fixed period of time after the
leading edge of the paper passes each drawer feed sensors (S34, 40, 46, 52).
↓
Paper jam (E230, E240, E250, E370, E380, E3F0)
• When a sheet of reversed paper is transported, horizontal transport sensor-1, -2 (S19, 20) or
reverse sensor-1 (S23) does not detect paper within a fixed period of time.
↓
Paper jam (E511, E512, E540)