13
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
FUSER UNIT
13 - 17
[B] Fuser unit
(4) Disconnect 3 connectors and remove 6
screws to take off the IH board.
Fig. 13-14
(1) Remove 2 screws and open the IH cover-1
carefully to the front side.
(2) Remove 2 screws to take off a knob cover.
Fig. 13-15
(3) Remove 4 screws and then release 4 power
supply harnesses of the IH coil.
(4) Disconnect 4 connectors.
(5) Remove 2 screws and open the IH cover-2 to
the front side.
Fig. 13-16
Connector
(
Yellow
)
Connector
(
White
)
Connector
Heater control PC board Screw
Screw
Screw
Screw
Knob cover
Screw
Connector
Connector
Screw
Screw
Screw
IH cover-2
To Next Page
Loading...
