Toshiba GX9 - Page 64

52 GX9 ASD Installation and Operation Manual
P ROTECTION
Overload
Motor Overload Protection F017
OL Reduction Starting Frequency F606
Motor 150% OL Time Limit F607
Trip Settings
Retain Trip Record at Power Down F602
Phase Loss
Output Phase Failure Detection Enable/
Disable
F605
Low Current Settings
Low Current Trip Enable/Disable F610
Low Current Detection Current F611
Low Current Detection Time F612
Abnormal Speed Settings
Abnormal Speed Detection Time F622
Over-Speed Detection Frequency Upper Band F623
Over-Speed Detection Frequency Lower
Band
F624
Over-Torque Settings
Over-Torque Trip Enable/Disable F615
Over-Torque Detection Level During Power
Running
F616
Over-Torque Detection Level During
Regenerative Braking
F617
Over-Torque Detection Time F618
Base Frequency Voltage
Supply Voltage and Output Voltage
Compensation/Limiting Enable/Disable
F307
Special Protection
Parameters
Short Circuit Detection at Start F613
Short-Circuit-Pulse Run Duration F614
Cooling Fan Control F620
Cumulative Run-Timer Alarm Setting F621
Braking Answer Wait Time F630
Brake Release After Run Timer F632
Suppression of Inrush-Current Timing F609
T ORQUE
Set Points
VI/II Point 1 Torque F205
VI/II Reference Point 1 F201
VI/II Point 2 Torque F206
VI/II Reference Point 2 F203
RR Input Point 1 Torque F214
RR Reference Point 1 F210
RR Input Point 2 Torque F215
RR Reference Point 2 F212
RX Input Point 1 Torque F220
RX Reference Point 1 F216
RX Input Point 2 Torque F221
RX Reference Point 2 F218
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number