3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
Satellite Pro M10 Series Maintenance Manual (960-431) 3-5
3. Select the option you want to execute and press Enter. When “1-SYSTEM TEST” is
selected, the following message will appear:
SUB-TEST MENU :
01 - ROM checksum
02 - Dock/Undock
03 -
04 - Fan ON/OFF
05 - Geyserville
06 - Quick charge
07 - DMI read
08 - DMI write
09 -
10 - CPU Temperature
99 - Exit to DIAGNOSTIC TEST MENU
↑↓
→←
: Select items
Enter: Specify
Esc : Exit
SYSTEM TEST
SUB-TEST : XX
PASS COUNT: XXXXX
WRITE DATA: XX
ADDRESS : XXXXX
XXXXXXX
ERROR COUNT: XXXXX
READ DATA : XX
STATUS : XXX
xxxxxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
NOTE: The menu displayed by your computer may be slightly different from the
one shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The
following message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns the subtest menu to the main menu after the test is complete.
To Next Page
Loading...
