4.30 TFT FL (Model 15.0 XGA LG. Philips LP150X06 A2) 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-111
4.30 TFT FL (Model 15.0 XGA LG. Philips LP150X06 A2)
CAUTION: When you replace the fluorescent lamp, wear finger covers or gloves to
avoid contaminating or damaging the LCD panel. Be careful not to let dust or other
foreign matter into the module.
Removing the TFT FL (Model 15.0 XGA LG. Philips LP150X06 A2)
To remove the TFT FL (Model 15.0 XGA LG. Philips LP150X06 A2), follow the steps
below and refer to figures 4-82 to 4-85.
1. Disassembly of Tape adhesive used for B/L Wire fixing. Pressure or stress should not
be given on B/L Wire.
2. Disassembly of Cover shield (G). Pressure or stress should not be given on Gate TCP.
3. Disassembly of Cover shield (C). Pressure or stress should not be given on Source
PCB. Usage of gloves with anti-electric discharge coating is recommended. To
eliminate possible damage on circuits occurred by ESC.
4. Disassembly of Tape shield a Tape Adhesive used for Top case fixing. Pressure or
stress should not be given on Top case during this process
Figure 4-82 Disassembly of outside tape and cover shield
To Next Page
Loading...
