4 Replacement Procedures 4.20 VGA Board
4-62 Satellite Pro M10 Series Maintenance Manual (960-431)
4.20 VGA Board
Removing the VGA Board
To remove the VGA board, follow the steps below and refer to Figure 4-42.
1. Remove three M2×4 screws securing the VGA board.
2. Gently lift up the VGA board to disconnect it from PJ100 on the system board.
M2×4 screws
VGA board
PJ100
VGA board's connector
Figure 4-42 Removing the VGA board
Installing the VGA Board
To install the VGA board, follow the steps below and refer to Figure 4-42.
1. Seat the VGA board and connect it to PJ100 on the system board.
2. Secure the VGA board with three M2×4 screws.
To Next Page
Loading...
