4.24 LCD Module 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-73
Installing the LCD Module
To install the LCD module, follow the steps below and refer to Figures 4-48 to 4-50.
1. Seat two metal braces and secure each with two silver super flat-head M2×3
screws.
2. Connect the LCD/FL cable to the LCD module.
3. Secure the LCD/FL cable with the tape.
4. Seat the LCD module and secure it with four M2×4 flat-head screws.
CAUTION: Make sure the cables lie inside the guide. Be careful not to damage or pinch
any cables when you seat the LCD module.
To Next Page
Loading...
