Toshiba Satellite Pro M10 Series - Top Cover with Display Assembly; Removing the Top Cover with Display Assembly

4.15 Top Cover with Display Assembly 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-49
4.15 Top Cover with Display Assembly
Removing the Top Cover with Display Assembly
To remove the top cover with display assembly, follow the steps below and refer to Figures
4-32 to 4-35.
1. Turn the computer upside down.
2. Remove one M2.5×6 black flat-head screw and two M2.5×4 black flat-head screw
securing the CPU/MDC slot cover to remove it, if necessary.
3. Remove the following five screws:
• Two M2.5×16 black flat-head screws
• Three M2.5×6 black flat-head screws
M2.5×6 black flat-head screw
M2.5×16 black flat-head screw
M2.5×16 black flat-head screw
M2.5×6 black flat-head screw
M2.5×6 black flat-head screw
Figure 4-32 Removing the screws from the bottom of the computer