4.19 System Board 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-61
4. Remove two strips of tape securing the modem cable.
5. Disconnect the modem cable from PJ2018 on the system board.
PJ2018
Modem cable
Tapes
Figure 4-41 Removing the modem cable
Installing the System Board
To install the system board, follow the steps below and refer to Figures 4-39 to 4-41.
1. Connect the modem cable to PJ2018 on the system board.
2. Secure the modem cable with two strips of tape.
3. Connect AC adaptor jack to PJ8800 on the system board.
4. Seat the system board. Be sure to align the sliding lever of the wireless
communication switch with S2302 on the system board.
5. Seat the AC adaptor jack.
To Next Page
Loading...
