4 Replacement Procedures 4.13 Bluetooth Module
4-46 Satellite Pro M10 Series Maintenance Manual (960-431)
Installing the Bluetooth Module
To install the Bluetooth module, make sure that the computer is in boot mode and powered
off, follow the steps below and refer to Figure 4-30.
NOTE: The Bluetooth module is an option in some models.
1. Connect the Bluetooth module cable to the connector on the Bluetooth module.
2. Seat the Bluetooth module and secure it with two M2×4 screws.
3. Connect the Bluetooth module cable to PJ4900 on the system board.
4. Secure the Bluetooth module cable with the insulator.
5. Connect the Bluetooth antenna coaxial cable (brown) to the connector on the
Bluetooth module.
To Next Page
Loading...
