4 Replacement Procedures 4.8 Switch Board
4-34 Satellite Pro M10 Series Maintenance Manual (960-431)
4.8 Switch Board
Removing the Switch Board
To remove the switch board, make sure the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-22.
1. Disconnect the switch board cable from PJ2025 on the system board.
2. Remove two M2.5×3 black flat-head screws.
3. Remove the switch board.
Switch board cable
PJ2025
M2.5×3 black flat-head screws
Switch board
Figure 4-22 Removing the switch board
To Next Page
Loading...
