Toshiba Satellite Pro M10 Series - Installing the Sound Board; Removing the Sound Board

4 Replacement Procedures 4.16 Sound Board
4-54 Satellite Pro M10 Series Maintenance Manual (960-431)
4.16 Sound Board
Removing the Sound Board
To remove the sound board, follow the steps below and refer to Figure 4-36.
1. Remove two M2.5×4 screws securing the sound board.
2. Gently lift up the sound board to disconnect it from PJ5006 on the system board.
M2.5×4 screws
Sound board
Sound board's connector
PJ5006
Figure 4-36 Removing the sound board
Installing the Sound Board
To install the sound board, follow the steps below and refer to Figure 4-36.
1. Seat the sound board to connect it to PJ5006 on the system board.
2. Secure the sound board with two M2.5×4 screws.