4 Replacement Procedures 4.9 Speakers
4-38 Satellite Pro M10 Series Maintenance Manual (960-431)
Installing the Speakers
To install the speakers, follow the steps below and refer to Figures 4-23 and 4-24.
1. Seat each of the speaker and secure it from one latch.
2. Secure each of the speaker with one M2.5×4 black flat-head screw.
3. Route two speaker cables through their hooks.
4. Connect the right speaker cable (red) to PJ5004 on the system board.
5. Connect the left speaker cable (blue) to PJ5005 on the system board.
6. Close the display panel and turn the computer upside down.
7. Secure each of the speaker with one M2.5×16 black screw.
To Next Page
Loading...
