Toshiba Satellite Pro M10 Series - Installing the Slim Select Bay Module

4.4 Slim Select Bay Module 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-21
Installing the Slim Select Bay Module
To install the slim select bay module, follow the steps below and refer to Figures 4-9 and 4-
10.
1. Seat the ODD in the ODD bracket.
2. Secure the ODD bracket to the ODD with five M2×3 thin silver flat-head screws.
3. Connect the ODD interface board to the ODD.
4. Seat the connector cover and secure it to the ODD with two M2×8 black screws.
5. Insert the module into the slim select bay and press it gently until the latch clicks.
6. Set one M3×4 black flat-head screw in the lock position, if necessary.