Toshiba Satellite Pro M10 Series - Page 232

4 Replacement Procedures 4.4 Slim Select Bay Module
4-20 Satellite Pro M10 Series Maintenance Manual (960-431)
NOTE: If you are going to replace an ODD, follow the steps below to disassemble the
slim select bay module.
3. Remove two M2×8 black screws securing the connector cover.
4. Remove the connector cover and ODD interface board.
5. Remove five M2×3 thin silver flat-head screws securing the ODD bracket.
6. Remove the ODD bracket.
M2×3 thin silver flat-head screws
M2×8 black screws
M2×3 thin silver flat-head screws
ODD bracket
ODD interface board
Connector cover
ODD
M2×3 thin silver flat-head screws
Figure 4-10 Disassembling the optical disk drive