4 Replacement Procedures 4.29 TFT FL (Model 15.0 XGA Samsung LTN150X6-L01)
4-110 Satellite Pro M10 Series Maintenance Manual (960-431)
Installing the TFT FL (Model 15.0 XGA Samsung LTN150X6-L01)
To install the TFT FL (Model 15.0 XGA Samsung LTN150X6-L01), follow the steps below
and refer to Figures 4-73 to 4-81.
1. Seat the FL in its groove on the mold frame.
2. Route the HV cable through its guide.
3. Lay the lamp cover on the mold frame and secure it with two screws.
4. Lay six sheets on the back light assembly and secure them with two clips.
5. Seat the panel assembly on the back light assembly.
6. Seat the top chassis and secure it with eight hooks.
7. Secure the chassis with four screws.
8. Secure the PCB with two screws.
9. Apply the PCB cover to the module.
To Next Page
Loading...
