Toshiba Satellite Pro M10 Series - Page 187

3.28 SETUP 3 Tests and Diagnostics
Satellite Pro M10 Series Maintenance Manual (960-431) 3-81
SYSTEM SETUP (2/2) ACPI BIOS version - x.xx
CONFIGURATION PC CARD
Device Config. = Setup by OS Controller Mode = Auto-Selected
I/O PORTS PERIPHERAL
Serial = COM1(3F8H/IRQ4) Internal Pointing Device = Enabled
Parallel = LPT1(378H/IRQ7/CH3) Ext Keyboard "Fn" = Disabled
Parallel Port Mode = ECP
DRIVES I/O Hard Disk Mode = Enhanced IDE(Normal)
Built-in HDD
= Primary IDE(1F0H/IRQ14) LEGACY EMULATION
Select Bay USB KB/Mouse Legacy Emulation
= Secondary IDE(170H/IRQ15) = Enabled
USB-FDD Legacy Emulation = Enabled
PCI BUS PCI LAN
PCI BUS = IRQ10, IRQ11 Built-in LAN = Enabled
↑↓
→ :Select items Space,BkSp:Change values PgDn,PgUp:Change pages
Esc:Exit without saving Home:Set default values End:Save changes and Exit
→
NOTE:
1. Panel Power On/Off item appears only when the Power-up Mode is in Resume mode.
2. The USB FDD Legacy Emulation item appears under the LEGACY EMULATION
item only when Floppy Disk I/O is set to Disabled.
3. The LCD Display Stretch item appears under the Display item only when the LCD
screen resolution is XGA (1024 × 768 LCD).