4.31 TFT FL (Model 15.0 XGA Chi Mei N150X2-L01) 4 Replacement Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) 4-125
Installing the TFT FL (Model 15.0 XGA Chi Mei N150X2-L01)
To install the TFT FL (Model 15.0 XGA Chi Mei N150X2-L01), follow the steps below and
refer to Figures 4-90 to 4-95.
1. Seat the FL and secure it with two screws.
2. Seat the diffuser sheet, BEMIII-T sheet and the BEFIII-M sheet.
3. Apply two strips of tape to the LCD module.
4. Apply three spacers to the BEFIII-M sheet.
5. Seat the panel.
6. Turn the LCD module upside down.
7. Fold the X-PCB.
8. Seat the metal frame and secure it with latches.
9. Secure the metal frame with a hook and eight screws.
10. Secure the X-PCB with two screws.
11. Apply the protector film_X, yellow tape, and CU tape to the LCD module.
To Next Page
Loading...
